Grizzly T20644 instruction manual Operations, Loading

OPERATIONS

Loading

When replacing nails in your Model T20644, follow these guidelines:

Gauge:	15
Length:	11⁄4" -21⁄2"
Capacity:	80
Angle:	34°

Note: A number of manufacturers' nails may fit the Model T20644. However, for best performance, we recommend you use the following Grizzly nails:

G6085-G6088, G9545, G6090, G3693-

G3697.

To load your nailer:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Insert a nail stick into the T-slot at the top of the magazine as shown in Figure 3.

Pusher

Release

Figure 3. Loading finish nails into nailer.

3.Slide the nail stick all the way down to the nose of the nailer.

4.Pull the magazine pusher all the way back, then let it come forward until it rests against the end of the nail stick.

-10- T20644 34° Angle Finish Nailer–2½"