Compressed Air System
The Model H5570 is designed to be oper- ated at
maximum operating pressure for your model.
Before using your new nailer, install the included 1⁄4" NPT male quick connect fitting on the nailer and a 1⁄4" NPT female fitting on the air hose. Regulate the air pressure on your air compressor to barely over the minimum psi for your model.
Many pneumatic tools benefit from an in- line filter/lubricator/regulator unit. Using this unit protects your tool from damaging water
Exceeding the maximum permissible operating pressure may cause the nailer to explode, blowing metal frag- ments in all directions. To protect yourself from serious personal injury, DO NOT allow your air compressor to exceed the recommended pressure when connected to this nailer!
H5570 18 Gauge Finish Angle Nailer
Safety Yoke Mechanism
A safety yoke mechanism (bump fire) on the nose of the nailer acts as a secondary safety device. When the trigger is pressed, the nailer will not fire until the safety yoke mechanism is depressed.
Before you use your nailer for the first time, check the safety yoke mechanism to ensure proper function. To do this:
1.Make sure the nailer is disconnect- ed from the air supply!
2. Make sure the magazine is empty and contains no nails.
3.Make sure the trigger and the safety yoke mechanism move up and down without sticking.
4.Connect the nailer to the air supply.
5.Without pressing the trigger, depress the safety yoke mechanism against a scrap piece of wood that is clean and free of any knots, nails, or other foreign objects. If the nailer does not fire, then the safety yoke mechanism is working correctly. If the nailer does fire when you do this, immediately disconnect the nailer from the air supply and call our cus- tomer service for help.
Similarly if the nailer fires when the trigger is pulled, without the safety yoke mecha- nism being depressed, then the nailer is not working properly.
If either of these two conditions develop after you have used your nailer for a peri- od of time, check the lubrication of these mechanisms.
The safety yoke is a mechanical device that can fail. Never rely on the safety yoke mechanism as an excuse to point the nailer at yourself or any bystanders. Serious injury may occur.