Grizzly G6045 instruction manual Troubleshooting, Problem Cause Action

TROUBLESHOOTING

PROBLEM		CAUSE					ACTION
Air leaking at trigger valve	1. O-rings		in trigger		valve	1.	O-rings must be replaced
area.		housing are damaged.					& operation		of	safety
							yoke must be checked.
Air leaking between hous-	1. Loose screws in housing.					1.	Tighten screws.
ing and hose.	2. Damaged O-ring.					2.	Replace O-ring.
	3.	Damaged bumper.				3.	Replace bumper.
Air leaking between hous-	1. Damaged seal.					1.	Replace damaged seals.
ing and cap assembly.
Tool skips nails while dis-	1. Air leaks.					1.	Tighten screws and fit-
charging.							tings.
	2.	Dirt in nose.				2.	Clean nose.
	3.	Dirt or	damage	prevents		3.	Clean	magazine		and
		nails from moving freely in					inspect/repair damage.
		magazine.
	4.	Inadequate air flow to tool.				4.	Check	fitting,	air	hose,
							and air compressor.
	5.	Worn O-ring on piston or				5.	Replace piston O-ring.
		lack of lubrication.					Lubricate.
	6.	Damaged O-rings on trigger				6.	Replace trigger valve O-
		valve.					rings.
	7.	Worn bumper.				7.	Replace bumper.
	8.	Cap seal leaking.				8.	Replace cap seal.
Tool runs slowly or has a	1. Nailer is not sufficiently lubri-					1.	Lubricate nailer.
loss of power.		cated.
	2.	Broken	spring	in	cap	2.	Replace spring.
		assembly.
	3.	Exhaust port in cap is				3.	Replace damaged			inter-
		blocked.					nal parts.
Fasteners frequently jam	1. Nails are the wrong size.					1.	Use correct nails.
the nailer.	2. Nails are bent.					2.	Use undamaged nails
	3.	Magazine or nose screws				3.	Tighten magazine and
		are loose.					nose screws.
	4.	Driver or driver guide are				4.	Replace worn or dam-
		worn or damaged.					aged parts.
Nailer does not fire.	1. Nail is jammed in maga-					1.	Clear nailer magazine or
		zine or discharge area.					discharge area.
	2. Piston shaft is damaged.					2.	Replace piston shaft.
	3. Air pressure too low.					3.	Check/increase air pres-
							sure.

-16- G6045/G6046/G6047 18 Gauge Brad Nailer