SAFETY
For Your Own Safety Read Instruction Manual
Before Operating This Equipment
The purpose of safety symbols is to attract your attention to possible hazard- ous conditions. This manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. The progression of symbols is described below. Remember that safety messages by themselves do not eliminate danger and are not a substitute for proper accident prevention measures.
Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.
| Indicates a potentially hazardous situation which, if |
| not avoided, COULD result in death or serious injury. |
| Indicates a potentially hazardous situation which, if |
| not avoided, MAY result in minor or moderate injury. It |
| may also be used to alert against unsafe practices. |
NOTICE | This symbol is used to alert the user to useful informa- |
tion about proper operation of the equipment. |
Safety Instructions For Pneumatic Tools
1. | KEEP ALL SAFETY DEVICES IN | 5. | KEEP CHILDREN AND VISITORS |
| PLACE and in working order. |
| AWAY. All children and visitors |
2. | REMOVE ADJUSTING KEYS AND |
| should be kept at a safe distance |
| WRENCHES. Form habit of check- |
| from work area. |
| ing to see that keys and adjusting 6. | MAKE WORKSHOP CHILD PROOF | |
| wrenches are removed from tool |
| by locking your shop and shutting off |
| before operation. |
| air valves. |
3.KEEP WORK AREA CLEAN. 7. DO NOT FORCE TOOL. It will do
Cluttered areas and benches invite |
| the job better and safer at the rate for |
accidents. |
| which it was designed. |
4. DO NOT USE IN DANGEROUS | 8. | USE THE RIGHT TOOL. Do not |
ENVIRONMENT. Do not use pneu- |
| force tool or attachment to do a job |
matic tools in damp or wet locations, |
| for which it was not designed. |
or where any flammable or noxious | 9. | DO NOT USE UNDER THE |
fumes may exist. Keep work area |
| INFLUENCE OF DRUGS OR |
well lighted. |
| ALCOHOL. |
|
|
|
H5527 18 Gauge Brad Nailer |
|