Grizzly H5571 instruction manual Operation, Oiling Nailer, Loading Nailer

Page 7

OPERATION

Oiling Nailer

Special oil has been included with your new Grizzly nailer to help maintain its use- ful life. Place one drop of oil in the nailer air inlet (as shown in Figure 1) before every use. Wipe off any excess oil near the nail- er exhaust to avoid dust build-up. When the oil that was included with the nailer has been completely used, replace with Grizzly Model G2820 Pneumatic Tool Oil.

Another option to manual oiling would be to install a lubricator in your air compressor line. If your air compressor line already has a lubricator, then regular lubrication of your nailer will not be necessary. Just make sure there is always oil in the lubricator.

As mentioned before, the best option is to install a filter/lubricator/regulator unit avail- able in the Grizzly catalog.

Figure 1. Lubricating nailer via air inlet.

Loading Nailer

To load your nailer:

1.Disconnect the air supply from the nailer!

2.Pull the magazine pusher all the way back until it locks in place.

3.Place a stick of nails into the maga- zine as shown in Figure 2. Make sure the pointed ends of the nails are fac- ing down.

Figure 2. Loading the nailer.

3.Slide the stick of nails all the way down to the nose of the nailer.

4.Pull the magazine pusher all the way back, release the catch lever, then let it come forward until it rests against the nail stick.

When choosing nails for your Model H5571, follow these guidelines:

Diameter: 0.113" - 0.162"

Length: 2"-312"

Capacity: 50 Nails

-6-

H5571 34˚ Framing Nailer Kit

Image 7
Contents Model H5571 34˚ Framing Nailer KITBefore Operating This Equipment SafetyWear Approved Hearing Protection Basic Nailer Safety Commentary IntroductionCompressed Air System Safety Yoke MechanismOiling Nailer OperationLoading Nailer Operating Nailer Adjusting DepthClearing Jammed Nails Single/Bump Fire ModeCleaning Nailer Replacing Pistons/O-Rings Part Breakdown Description Problem Cause Action TroubleshootingWarranty and Returns Warranty Card Place Stamp Here