Grizzly H6141 owner manual Troubleshooting, Symptom Possible Cause Possible Solution

TROUBLESHOOTING

Symptom	Possible Cause		Possible Solution
Air leaking between	1.	Loose screws in housing.	1.	Tighten screws.
housing and hose.	2.	Damaged O-ring.	2.	Replace O-ring.
	3.	Loose air fitting.	3.	Tighten air fitting and use
				teflon tape.
Air leaking between	1.	Damaged gasket.	1.	Replace damaged gasket.
housing and cap
assembly.
Tool skips on nail head	1.	Air leaks.	1.	Tighten screws and fittings.
while discharging.	2.	Dirt in cylinder.	2.	Clean cylinder and housing.
	3.	Inadequate air flow to	3.	Check fitting, hose, compres-
		tool.		sor and air pressure.
	4.	Worn O-ring on piston or	4.	Replace piston O-ring.
		lack of lubrication.		Lubricate.
	5.	Gasket leaking.	5.	Replace gasket.
Tool drives nails too	1.	Broken spring.	1. Replace spring.
far; depth guide is	2.	Loose nose piece.	2.	Tighten nose piece and use
loose.				teflon tape.
Nailer does not fire.	1.	Piston shaft damaged.	1.	Replace piston shaft.
	2.	Air pressure too low.	2.	Check/increase air pressure.

-12- H6141 Air Palm Nailer