13.DISCONNECTTOOL when not in
use, before servicing and when loading or changing accessories.
14.AVOID UNINTENTIONAL
STARTING. Never carry tool with your finger on the switch.
15.STAY ALERT, Watch what you are doing and use common sense. Do
not operate tool when you are tired
or under the influence of drugs, alcohol, or medication.
16.CHECK DA;w;AGED PARTS. Before
using tool, check that all parts will operate correctly and will perform as
17.REPLACEMENT PARTS, When servicing, use only identical replacement parts ordered from a Sears service facility.
18.WEAR HEARING PROTECTION
during extended periods of operation.
GUIDELINES FOR
EXTENSION CORDS
If you are using an extension cord outdoors, be sure it is marked with the suffix
designed. Any damaged parts should be repaired or replaced by an authorized Sears service facility. Also, check for misalignment, binding, and broken parts. Check that the switch works properly and
DO NOT USETOOL IFTHE
SWITCH DOES NOTTURN THE TOOL ON AND OFF.
Be sure your extension cord is properly wired, and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified person before using it.
Protect your extension cords from sharp objects, excessive heat and damp or wet areas.
|
| (when using 120 volts only) |
|
| |
Ampere | Rating | Totallengthofcordln | feet |
| |
more than | not more than | 25' | 50' | 100' | 150' |
0 | 6 | 18 | 16 | 16 | 14 |
6 | 10 | 18 | 16 | 14 | 12 |
10 | 12 | 16 | 16 | 14 | 12 |
ALWAYS WEAR EYE PROTECTION. Any Power Tool
WEAR YOUR
can throw foreign objects into4he eyes which could cause permanent eye damage. ALWAYS wear safety Goggles (not glasses) that comply with ANSI safety standard Z87.!. Everyday glasses have only
NOTE: Glasses or goggles not in compliance with ANSI Z87.1 could seriously hurt you when they break.
SAVE THESE INSTRUCTIONS
Page 4