Woodstock W1827 manual ?fc$fnej, KfXjj\dYc\k\fc$fnej#fk\j\jk\gj1

Df[\cN(/).=fiDXZ_`e\jD]^%J`eZ\*&()

?fc[$;fnej

Each hold-down is independently adjustable, and, when properly positioned, they firmly hold the workpiece flat on the table and against the fence, as shown in =`^li\*+.

KfXjj\dYc\k_\_fc[$[fnej#[fk_\j\jk\gj1

(% DISCONNECT SHAPER FROM POWER!

)% Slide a hold-down into each of the cast iron hold- down brackets with the large holes, and secure them with the lock handles.

*% Insert the bracket bars into the fence brackets and hold-down bracket.

+% Position the above assemblies according to the workpiece size, then use the lock handles to secure them in place.

,% Insert the 5⁄16"–18 x 3/8" knob bolts with the 21⁄2" shafts into two hold-down brackets with the small holes and loosely thread the T-nuts onto the knob bolts.

-%Slide the assemblies from Jk\g, into the table miter slot, position them according to the workpiece size, then tighten the knob bolts to secure their position.

8cnXpj n\Xi jX]\kp ^cXjj\j fi X ]XZ\ j_`\c[ n_\e fg\iXk`e^k_`jdXZ_`e\kfXmf`[\p\fi]XZ\`eali`\j ]ifd ]cp`e^ [\Yi`j% Nff[ [ljk dXp ZXlj\ j_fik Xe[ cfe^$k\id i\jg`iXkfip `cce\jj% Kf Xmf`[ k_`j _XqXi[# XcnXpjn\XiXi\jg`iXkfi[li`e^fg\iXk`fe%

@] k_\ nfibg`\Z\ j_flc[ i`j\ lg n_\e `k`jX^X`ejkk_\Zlkk\i#b`ZbYXZbZflc[ fZZli%Kfi\[lZ\k_\Z_XeZ\f]b`ZbYXZb Xe[ j\i`flj g\ijfeXc `ealip# XcnXpj gifg\icpj\Zli\k_\nfibg`\Z\n`k_k_\ _fc[$[fne[\m`Z\j[li`e^fg\iXk`fe%

=`^li\*+% Example of workpiece held in

place by hold-downs.

=`^li\*,% Hold-downs assembled and

installed.

FG<I8K@FEJ

-27-