Woodstock W1702 instruction manual General, Table and Base, Lubrication

Page 46

MAINTENANCE

General

Regular periodic maintenance on your Model W1702 Shaper will ensure its optimum performance. Make a habit of inspecting your shaper each time you use it. Check for the following conditions and repair or replace parts when necessary.

1.Loose mounting bolts.

2.Worn switch.

3.Worn or damaged cords and plugs.

4.Damaged drive belt.

5.Any other condition that could hamper the safe operation of this machine.

Table and Base

The table can be kept rust-free with regular applications of products like Boeshield® T-9. For long term storage you may want to consider products like Kleen Bore's Rust Guardit™.

Lubrication

Since all bearings are shielded and permanently lubricated, simply leave them alone until they need to be replaced. Do not lubricate them.

For other items on this machine, an occasional application of light machine oil is all that is necessary. Before applying lubricant, clean off sawdust.

Your goal is to achieve adequate lubrication. Too much lubrication will attract dirt and sawdust. Various parts of your machine could lose their freedom of movement as a result.

UNPLUG the power cord before you do any assembly, adjustments, or maintenance tasks! Otherwise, serious personal injury to you or others may occur!

KEEP loose clothing rolled up and out of the way of machinery and keep hair pulled back.

WEAR your safety glasses and dust mask during any machine operation or maintenance. Failure to comply may result in serious personal injury.

MAINTENANCE

-32-

Image 46

Contents HP Shaper Model W1702 3HP Shaper Machine Specifications 220V/240V Single-PhaseFull Load Current Rating Amps 60 HzMinimum Gauge Size 14 AWG 50 ftReplaces Cutter DirectionMain Parts Diagram Replaces Main Parts List Replaces Safety Guard Parts Replaces Pages Model W1702 Manual Update Box #2 Box #1Box #3 To install the switches, do these steps To install the handwheel and handle, do these stepsFence Housing Assembly To mount the fence housing assembly, do these stepsPage Contents Woodstock Service and Support About Your New ShaperWarranty and Returns SpecificationsSafety Standard Safety InstructionsSafety Additional Safety Instructions for Shapers Avoiding Potential Injuries Use a Shop FOX Featherboard asExtension Cords 220V OperationGrounding Unpacking InventoryInitial Cleaning BeginningDust Collection Shop PreparationFence Facing Safety GuardAuxiliary Guard Hold-Downs To install the hold-downs, do these stepsTo install the crank handle, do these steps HandwheelSpindle Unplug the ShaperThreading drawbar nut onto drawbar To adjust the fence, do these steps Fence PositioningFence Alignment To adjust the table inserts, do these steps Table InsertsPulley Alignment To align the pulleys, do these stepsChoose Spindle RPM Spindle RPMTo change the spindle RPM, do these steps Spindle Slide and Gib To check the spindle slide-to-gib clearance, do these stepsOperations Start UpForward and reverse switch Choose Cutter Height and Spindle Size Cutter InstallationChoose Cutter Profile and Cutter Choose Spindle and Cutter RPMPlace the spindle washer onto the spindle as shown in Figure Setting Spindle Height To set the spindle height, do these stepsStraight Shaping Operations There are three set up positions for rub collars Rub CollarsFreehand Shaping Starting pin operation Guard not shown for clarityPattern Shaping To make a template, do these stepsTable and Base GeneralLubrication Troubleshooting Closure Model W1702 220V Wiring Diagram Parts Stand Parts Handle Parts XPR15M Parts XPW02 Lock Washer 3⁄8 Parts Miter Gauge Body HOLD-DOWN BAR Shaper Accessories Shaper Accessories Your Notes Your Notes Warranty Card BOX BELLINGHAM, WA