Woodstock M1051 owner manual Test Run, To perform a test run, do these steps

Page 12

M1051 6" Bench Grinder

Test Run

Once your machine is mounted and assembled, you should perform a test run to make sure it works properly.

To perform a test run, do these steps:

1.Make sure all tools are removed from the grinder area.

2.Make sure the switch is in the OFF position.

3.Plug the grinder into the power source.

4.Move the switch to the ON position.

•Under normal conditions, the grinder will make a loud humming noise, with only minor vibration.

•If you hear or see anything unusual with the grinder, turn it OFF, unplug it, and troubleshoot the cause the problem. If you CANNOT determine the source of the problem, call our tech support BEFORE starting the machine again.

SET UP

DO NOT investigate problems or adjust the bench grinder while it is running. Wait until the machine is turned OFF, unplugged and the spindle has come to a complete stop before proceed- ing!

-10-

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Bench Grinder Page Contents Machine Specifications IntroductionWoodstock Technical Support About Your New 6 Bench GrinderSafety Standard Safety InstructionsKeep Proper Footing and Balance at all times Additional Safety Instructions for Grinders Electrical 110V OperationExtension Cords GroundingSET UP Box ContentsUnpacking InventoryShop Preparation MountingTo mount the bench grinder, do these steps Grinding Wheel Installation Tool Rest and Eye ShieldTest Run To perform a test run, do these stepsOperations GeneralGrinding Operations Wheel Selection Changing Grinding Wheels To change a grinding wheel, do these stepMaintenance Lubrication & CleaningTroubleshooting Problem Possible Cause Corrective ActionM1051 Breakdown Parts Warranty Warranty Registration CommentsBOX BELLINGHAM, WA
Top Page Image Contents