How to Assemble Your Light Kit Glass Shade

BP7408 44" & 52" Curva 1/12/10 8:52 AM Page 11

How to Assemble Your Light Kit Glass Shade

1. Screw in two 50-watt (maximum) halogen mini candelabra base bulbs in the light kit plate sockets (Figure 15).

LIGHT KIT PLATE

SOCKETS (2)

50-WATT (maximum) HALOGEN MINI CANDELABRA BASE BULBS (2)

Figure 15

How to Assemble Your No Light Cover Plate

! WARNING

Do not install any light bulbs into the light kit plate if using the cover plate. Installation of light bulbs when using the cover plate could result in fire, shock and serious personal injury.

1. Place the cover plate onto the lower housing aligning the three flat areas on the top flange of the cover plate with the three pins on the inside of the fan motor housing assembly (Figure 17). Then turn the cover plate clockwise until it stops turning.

2. Your cover plate is now installed

2. Place the glass shade into the opening in the fan motor housing assembly, aligning the three flat areas on the top edge of the glass with the three raised dimples on the fan motor housing assembly and turn the glass shade clockwise until it stops (Figure 16).

NOTE: periodically check that the glass shade is seated fully clockwise in the fan motor housing assembly.

FLAT AREA (3)	DIMPLES (3)

GLASS

BOWL

Figure 16

DO NOT INSTALL LIGHT BULBS

WHEN USING THE COVER PLATE

FLAT AREA (3)	DIMPLES (3)

COVER

PLATE

Figure 17

11	UL Model No.: CF244 & CF252