Delta 66-750 instruction manual Tools Required for Assembly, Unpacking, To Add Oil To Pump

Page 9

ASSEMBLY

Tools Required for Assembly

1 - 9/16" socket or open end wrench

1 - electric drill

Unpacking

1.Remove all packaging.

It may be necessary to brace or support one side of the outfit when removing the pallet because the air

compressor will have a tendency to tip.

2.Remove and discard the (4) screws and washers holding the compressor to the pallet.

3.With the help of another person carefully remove air compressor from pallet and place on a level surface.

To Add Oil To Pump

Compressors are shipped without oil. A small amount of oil may be present in the pump upon receipt of the air

compressor. This is due to plant testing and does not mean the pump contains oil. Do not attempt to operate this air compressor without first adding oil to the crankcase. Serious damage can result from even limited operation unless filled with oil and broken in correctly. Make sure to closely follow initial start-up procedures.

Multi-Viscosity motor oils, like 10W 30, should not be used in an air compressor. They leave carbon deposits on

critical components, thus reducing performance and compressor life. Use air compressor oil only.

NOTE: Oil is included with some units. If oil is not included, use an oil specifically formulated for use in an air compressor, such as Porter-Cable PAS1 air compressor oil. Oil may be found at the store where the air compressor was purchased.

1.Place unit on a level surface.

Drain tank to release air pressure before removing

the oil fill cap or oil drain plug.

2.Remove oil fill plug (A) and slowly add compressor oil until it is even with the top of the oil fill hole. NOTE: Do not allow oil to be lower than 3/8" (6 threads) from the top at any time. When filling the crankcase, the oil flows very slowly into the pump. If the oil is added too quickly, it will overflow and appear to be full. NOTE: Crankcase oil capacity is approximately 16 fluid ounces.

3.Replace oil fill plug.

A

9-ENG

D26269

Image 9
Contents Structioin N M Anual Safety Guidelines Definitions Hazard Attachments & Accessories Hazard What can Happen HOW to Prevent IT Fire, Inhalation, Damage to Vehicle Surfaces Accessories SpecificationsGlossary Duty CycleTools Required for Assembly AssemblyUnpacking To Add Oil To PumpInstallation Location of the Air CompressorAnchoring of the Air Compressor Wiring Instructions Voltage and Circuit ProtectionAir Distribution System Typical Compressed AIR Distribution System Know Your Air Compressor Description of Operation OperationPressure Release Valve The pressure How to StopBefore Each Start-Up Maintenance To Check Safety ValveCustomer Responsibilities Oil To Drain TankMotor Pulley/Flywheel Alignment Air Filter Inspection and ReplacementService and Adjustments Air Compressor Pump Intake and Exhaust ValvesInspect Air Lines and Fittings for Leaks To Replace or Clean Check Valve To Replace Belt StorageProblem Cause Correction TroubleshootingPressure reading D26269 24-ENG 25-ENG D26269 AIR Compressor Diagram KEY Description Parts ListPump Diagram KEY Limited Warranty