Parkside PSBM 850 manual Original accessories / attachments, Have you understood everything?

General safety advice for electrical power tools / Before first use

Always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area.

Warning! HAZARDOUS DUSTS! Working with harmful / poisonous dusts presents a danger to health for the tool operator and any persons in the vicinity.

Wear safety glasses and a dust protection mask!

JAvoid drilling paints containing lead or other substances hazardous to health.

JDo not drill or abrade materials containing asbestos. Asbestos is a known carcinogen.

JDo not drill moist materials or damp surfaces,

JWhen working always hold the device securely with both hands.

JIf the inserted tool jams, switch off the electrical power tool immediately. Be prepared for high reaction torques as they may cause kickback.

JAlways keep the device clean, dry and free of oil or grease.

QCaution utility services!

mDANGER! Ensure that you do not strike electrical cables, gas or water pipes when you are working with the electrical pow- er tool. Check a wall using a suitable detector before you drill or cut slots.

QOriginal accessories /  attachments

Use only the accessories and attachments detailed in the operating instructions. The use of inserted tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury.

QHave you understood everything?

Once you have made yourself familiar with this general safety advice for electrical power tools, and with the help of the device’s operating instructions

10 GB/IE/CY

you now know about all the functions of and how to handle your electrical power tool, you are finally in a position to start work. Observing the manufac- turer‘s instructions and advice will maximise your safety while working with the device.

QBefore first use

QAttaching the auxiliary handle

For safety reasons this tool must always be used with the auxiliary handle 7 in place.

jPlace the auxiliary handle 7 on the spindle collar and bring it round into the desired position. Tighten the auxiliary handle 7 in position.

jIf necessary fit the depth stop 9 .

QInserting a tool into the chuck

Warning! DANGER OF INJURY! Switch the device off and pull the plug out of the mains socket before carrying out any work on the device.

QOpening the chuck

Note: The directions of rotation are given relative to the device being held by you in the working position / „drill chuck pointing away from you“. Your 2-speed hammer-action drill has a fully auto-

matic spindle lock and is fitted with a single

sleeve chuck “Made in Germany” by .

The quick-release chuck 8 allows you to exchange drills or other tools without using a special key etc. The drive chain is locked when the motor comes to standstill so that the quick-release chuck 8 can be opened by turning it .

QTightening the chuck

After you have selected and inserted the tool and fixed the inserted tool in place by the turning the

E3334_PSBM 850_Content_LB6.indd 10

11.04.2008 13:28:29 Uhr