RIDGID R841151 manual Installing Bits, Removing Bits

Page 14

OPERATION

INSTALLING BITS

UNLOCK

See Figures 9 and 10.

(RELEASE)

„Lock the switch trigger by placing the direction of rotation selector in center position. See Figure 4.

„ Open or close chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of the drill slightly to keep the bit from falling out of the chuck jaws.

„ Insert drill bit straight into chuck the full length of the jaws as shown in figure 10.

„

Tighten the chuck jaws on the drill bit.

 

„

To tighten the chuck jaws on drill bit; grasp and hold the

LOCK

 

collar of the chuck with one hand, while rotating the chuck

(TIGHTEN)

 

body with your other hand.

 

Note: Rotate the chuck body in the direction of the ar- row marked LOCK to tighten chuck jaws.

„Do not use a wrench to tighten or loosen the chuck jaws.

WARNING:

Make sure to insert drill bit straight into chuck jaws. Do not insert drill bit into chuck jaws at an angle then tighten, as shown in Figure 9. This could cause drill bit to be thrown from drill, resulting in possible serious personal injury or damage to the chuck.

REMOVING BITS

See Figure 9.

„ Lock the switch trigger by placing the direction of rota- tion selector in center position. See Figure 4.

„Loosen the chuck jaws from the drill bit.

„To loosen: grasp and hold the collar of the chuck with one hand, while rotating chuck body with your other hand. Note: Rotate chuck body in the direction of the arrow marked UNLOCK to loosen chuck jaws.

„Do not use a wrench to tighten or loosen the chuck jaws.

„Remove the drill bit from the chuck jaws.

22 20

18

16

Fig. 9

22

20

18

16

Fig. 10

14

Image 14
Contents OPERATOR’S Manual Table of Contents IntroductionGeneral Safety Rules Model Battery Pack ChargerSpecific Safety Rules ServiceImportant Safety Instructions for Charger Symbols Symbol Name DESIGNATION/EXPLANATIONFeatures Battery Pack Dual Port Charger Depth Gage RODPacking List UnpackingInstructions Keeping the Charger Vents Clean Charging Battery PackImportant Information for RECHARG- ING HOT Battery Pack OperationLED Function of Charger Power IndicatorFull Indicator OFFApplications To Install Battery PackTo Remove Battery Pack Variable SpeedReversible TWO-SPEED Gear TrainInstalling Bits Removing BitsTo Adjust Torque Installing Depth Gage RODAdjustable Torque Clutch Drilling Metal Drilling To Adjust Drilling or Hammer ModeWood Drilling Masonry DrillingChuck Removal MaintenanceGeneral Batteries Battery Pack Removal Preparation for RecyclingTo Retighten a Loose Chuck CYCWhat is Covered Under the Limited Three Year Warranty WarrantyDAY Satisfaction Guarantee Policy HOW to Obtain Service What is not CoveredPage Customer Service Information