OPERATION
ADJUSTABLE TORQUE CLUTCH
See Figure 8.
This product is equipped with an adjustable torque clutch for driving different types of screws into different ma- terials. The proper setting depends on the type of material and the size of screw you are using.
ADJUSTING TORQUE
There are
Rotate the adjusting ring to the desired setting.
•1 - 4 For driving small screws
•5 - 8 For driving screws into soft material
•9 - 12 For driving screws into soft and hard materials
•13 - 16 For driving screws into hard wood
•17 - 23 For driving large screws
• | For heavy drilling |
BIT STORAGE
See Figure 9.
When not in use, the bit provided with this drill can be placed in the storage area located on the rear of the drill.\
INSTALLING BITS
See Figure 10 - 11.
Lock the switch trigger by placing the direction of rotation selector in the center position.
Open or close the chuck jaws to a point where the open- ing is slightly larger than the bit size you intend to use. Also, raise the front of the drill slightly to keep the bit from falling out of the chuck jaws.
Insert the drill bit.
WARNING:
Make sure to insert the drill bit straight into the chuck jaws. Do not insert the drill bit into the chuck jaws at an angle then tighten, as shown in figure 11. This could cause the drill bit to be thrown from the drill, resulting in possible serious personal injury or damage to the chuck.
�Tighten the chuck jaws securely on the bit.
NOTE: Rotate the chuck body in the direction of the ar- row marked LOCK to close the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws.
TO DECREASE | ADJUSTING |
TORQUE | RING |
TO INCREASE
TORQUE
Fig. 8
SCREWDRIVER BIT
BIT STORAGE AREA
Fig. 9
UNLOCK
(RELEASE)
LOCK
(TIGHTEN)
Fig. 10
14