RIDGID R84001 manual Drilling

Page 16

OPERATION

DRILLING

See Figure 13.

When drilling hard smooth surfaces use a center punch to mark desired hole location. This will prevent the drill bit from slipping off center as the hole is started. However, the low speed feature allows starting holes without center punching if desired. To accomplish this, simply operate the drill at a low speed until the hole is started.

The material to be drilled should be secured in a vise or with clamps to keep it from turning as the drill bit rotates.

Hold tool firmly and place the bit at the point to be drilled. Depress the switch trigger to start tool.

Move the drill bit into the workpiece applying only enough pressure to keep the bit cutting. Do not force or apply side pressure to elongate a hole.

WARNING:

Be prepared for binding or bit breakthrough. When these situations occur, drill has a tendency to grab and kick opposite to the direction of rotation and could cause loss of control when breaking through material. If not prepared, this loss of control can result in possible serious injury.

When drilling metals, use a light oil on the drill bit to keep it

 

from overheating. The oil will prolong the life of the bit and

 

increase the drilling action.

Fig. 13

If the bit jams in workpiece or if the drill stalls, release switch

 

trigger immediately. Remove the bit from the workpiece and

 

determine the reason for jamming.

 

16

Image 16
Contents OPERATOR’S Manual Table of Contents IntroductionGeneral Safety Rules Model Battery Pack ChargerSpecific Safety Rules ServiceImportant Safety Instructions for Charger Symbol Name DESIGNATION/EXPLANATION SymbolsSymbol Meaning Specifications UnpackingApplications InstructionsFeatures Torque Adjustment Ring Keyless Chuck Battery Pack Charger Charging Battery Pack Important Information for Recharging HOT Battery PackImportantinformationforrecharging Cool Battery Pack OperationPower Indicator Evaluate Charging Full LED Function of ChargerTo Remove Battery Pack To Install Battery PackVariable Speed Handle Assembly Toloosen Tighten ReversibleTWO-SPEED Gear Train TWO Speed Gear Train HI-LORemoving Bits Installing BitsUnlock Release Lock Tighten Wrong Adjustable Torque Clutch To Adjust TorqueDrilling Maintenance Chuck RemovalTo Retighten a Loose Chuck Mallet Chuck Jaws HEX KEY Keyless ScrewdriverGeneral Battery Pack Removal Preparation for RecyclingBatteries Warranty DAY Satisfaction Guarantee PolicyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredCustomer Service Information