Emerson CF710ORB01, CF710AB01, CF710BS01, CF710AW01, CF711CK01, CF711WW01 Unpacking Instructions

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One 1/4” blade screwdriver	One wire stripper
Three wire connectors (supplied).

Four 60-watt (max.) intermediate base bulbs (CF711) Three 60-watt (max.) intermediate base bulbs

(CF710)

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

! WARNING

Before assembling your ceiling fan, refer to section on proper method of wiring your fan (page 6). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

! WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

! WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

2.Remove the fan housing assembly from the protective plastic bag. Turn the upper styrofoam pad over and carefully place the fan motor assembly into the recess in the pad with the top of the motor facing up.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.Five fan blades

c.One ceiling cover

d.Five blade flanges

e.One hanger ball/downrod assembly

f.One hanger bracket

g.One switch housing cover

h.Glass shades (3 or 4)

i.One loose parts bag containing:

1.Sixteen M5 x 6 washer head blade screws

2.One rubber gasket

3.Two wood pendants

4.Two couplings

5.Three wire connectors

6.One clevis pin

7.One hairpin clip

8.One Phillips round head flange screw

LOOSE
PARTS	FAN MOTOR
BAG
	ASSEMBLY

GLASS	HANGER
	BRACKET
SHADES
(3 or 4)

HANGER BALL/		CEILING
DOWNROD
ASSEMBLY		COVER
SWITCH HOUSING	FAN
COVER		BLADE
	BLADES
		FLANGES

3 U.L. Model No.: 42-ANT/52-ANT