OPERATION
POSITIVE 0° BEVEL STOP
See Figure 22.
The saw has a positive 0° bevel stop that has been factory adjusted to assure 0° angle of the saw blade when making 90° cuts.
TO CHECK
nRemove battery pack from saw.
WARNING:
Failure to remove battery pack from saw could result in accidental starting, causing possible serious personal injury.
nPlace the saw in an upside down position on work- bench.
nUsing a carpenter’s square, check squareness of saw blade to the base of the saw.
TO ADJUST
nRemove battery pack from saw.
nLoosen bevel adjustment knob.
nLoosen hex nut securing adjustment screw.
nTurn screw and adjust base until square with saw blade.
nTighten hex nut and bevel adjustment knob securely.
CARPENTER’S
SQUARE
ADJUSTMENT
SCREW
HEX NUT
| 0 |
1 | 45 |
|
2
3
BLADE
BEVEL
ADJUSTMENT
KNOB
POSITIVE 0º
BEVEL STOP
Fig. 22
WARNING:
Attempting to make cuts without bevel adjustment knob securely tightened can result in serious injury.
20