RIDGID R3210 manual To Adjust Positive 0 Bevel Stop, To Adjust Bevel Setting, See Figures 16

Page 19

OPERATION

TO ADJUST POSITIVE 0° BEVEL STOP

See Figures 16 and 17.

nUnplug the saw.

nPull bevel adjustment lever upward to release.

nTurn set screw with hex wrench and adjust base until it is square with the saw blade.

nSecurely lock the bevel adjustment lever.

TO ADJUST BEVEL SETTING

See Figure 16.

nUnplug the saw.

nPull the bevel adjustment lever upward until the motor housing moves freely.

nRaise the motor housing end of the saw until you reach the desired angle setting on the bevel scale (0-45°).

Note: Pull the adjustment lever all the way up to set the angle at 51.5°. To reach the 51.5° bevel setting, push the 51.5° bevel button shown in figure 16.

nPress downward on the bevel adjustment lever until the motor housing is securely locked in place.

BEVEL

ADJUSTMENT

LEVER

51.5° BEVEL

BUTTON

Fig. 16

SET

SCREW

Fig. 17

Image 19

Contents Double Insulation Operators ManualIntroduction Table of ContentsWork Area General Safety RulesElectrical Safety Personal SafetyService Specific Safety RulesCauses and Operator Prevention of Kickback Additional Safety Rules Symbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Extension Cords ElectricalDouble Insulation Electrical ConnectionFeatures Features Instructions UnpackingPacking List Spring Washer AssemblyAttaching Blade See Figures 2 and 2aSee Figure Removing BladeSpindle Lock Button Wrench Blade Screw Blade Guard System OperationApplications SAW BladesSee Figures 5, 6, 7, KickbackSwitch Trigger Elevation Bracket Depth Adjustment Lever Adjusting Blade DepthSTARTING/STOPPING the SAW See Figures 11, 12, Operating the SAWLine CUT To Check Positive 0 Bevel Stop Cross CuttingBevel Cutting Positive 0 Bevel StopSee Figures 16 To Adjust Positive 0 Bevel StopTo Adjust Bevel Setting Bevel Adjustment LeverPocket Cutting To Bevel CUTNotch Notch Lower Blade Guard General MaintenanceLength of CUT Scale OIL Plug Brush ReplacementLubrication DIP StickHOW to Obtain Service What is not Covered WarrantyDAY Satisfaction Guarantee Policy What is Covered Under the Limited Three Year WarrantyDouble Insulated 4 Worm Drive SAW