How to Put Your Ceiling Fan Together

1.Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 5.

HANGER

BALL

DOWNROD

SETSCREW

Figure 1

4.Make sure the grommet is properly installed in the coupler cover, then slide the coupler cover on the downrod until it rests on the motor housing (Figure 3).

CEILING

COVER

DOWNROD

GROMMET

COUPLING COVER

2.Unscrew the two upper setscrews (Figure 2) until they clear the inside of the motor coupling. Then separate, untwist and unkink the three 80” motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 2). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the downrod to make sure the clevis pin is properly installed.

Figure 3

5. Place the ceiling cover over the downrod, making sure that the large opening faces upward (Figure 4).

HANGER	PIN
BALL
SETSCREW

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tight- ened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 2) could result in the fan falling.

MOTOR

COUPLING

	HAIRPIN	UPPER SETSCREW
		CLEVIS PIN
	CLIP

DOWNROD

CEILING COVER

Figure 4

6.Reinstall the hanger ball (Figure 4) on the downrod as follows. Route the three 80” motor leads through the hanger ball. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.

HAIRPIN CLIP

DOWNROD

CLEVIS

!WARNING

It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are proper- ly installed could result in the fan falling.

MOTOR COUPLING	UPPER
	SETSCREW

Figure 2

3.Tighten the two upper setscrews (Figure 2) secure- ly while pulling up on the downrod.

NOTE: The setscrews must be properly installed as described above, or fan wobble could result.

7.The fan comes with blue, black and white leads that are 80-inches long. Before installing the fan, measure up approximately 6 to 9-inches above top of hanger ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads.

8.Mount blade flanges to fan blades using three M5 x 6 washer head screws (Figure 5). Repeat for the remaining four blades.

4	U.L. Model No.: CF716