RIDGID R3203-1 manual Accessories, CHECKING/REPLACING External Brushes, 631697001

Page 22

MAINTENANCE

CHECKING/REPLACING EXTERNAL

BRUSHES

See Figure 25.

NOTE: The saw is equipped with externally accessible brushes.

 Unplug the saw.

WARNING:

Failure to unplug the tool could result in accidental starting causing possible serious injury.

NOTE: Brush caps (2) are located on each side of the motor housing.

Remove brush caps (2) using a screwdriver.

Remove brush assemblies (2).

Check for wear. Replace both brush assemblies when either has less than 1/4 in. length of carbon remaining.

NOTE: Do not replace one side without replacing the other.

Reassemble using new brush assemblies. Make sure curvature of brush matches curvature of motor and that brush moves freely in brush tube.

Reassemble by reversing the steps listed above.

Tighten all brush caps securely. Do not over tighten.

ACCESSORIES

Look for these accessories where you purchased this product:

	BRUSH
	CAP
	BRUSH
ASSEMBLY
45
30
22
15
BRUSH
ASSEMBLY
BRUSH CAP	Fig. 25
	Fig. 25

� Edge Guide

631697001

WARNING:

Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury.

22

Image 22

Contents OPERATOR’S Manual Double InsulatedTable of Contents IntroductionElectrical Safety General Safety RulesWork Area Safety Personal SafetySpecific Safety Rules Causes and Operator Prevention of KickbackSpecific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONService Symbol Signal MeaningDouble Insulation Cord Length Wire Size A.W.GElectrical Electrical ConnectionFeatures Product SpecificationsKnow Your Circular SAW Externally Accessible BrushesFront and Rear Kerf Indicators Detachable CordUnpacking AssemblyPacking List See Figures 2 Attaching BladeRemoving Blade HEX KEYApplications Correct Blade Depth Setting = Blade Exposed 1/4Operation KickbackSAW Blades Blade Guard SystemTo detach STARTING/STOPPING the SAWSee figures 9 To reattachAdjusting Blade Depth See Figures 12Operating the SAW See Figures 14See Figures 17 Cross CUTTING/RIP CuttingTo RIP CUT See Figures 18To Bevel CUT To Adjust Bevel SettingBevel Cutting See Figures 20Positive 0 Bevel Stop AdjustmentsPocket Cutting To check positive 0 bevel stopTo adjust positive 0 bevel stop MaintenanceGeneral Maintenance LubricationCHECKING/REPLACING External Brushes Accessories631697001 What is Covered Under the 3 Year Limited Service Warranty WarrantyDAY Satisfaction Guarantee Policy HOW to Obtain Service What is not CoveredCustomer Service Information Model No R3203-1 Serial No