Emerson CF759HTW00 Setting Remote Control Operating Frequency, Setting Transmitter Frequency

SUPPLY	BLACK AND BLUE
	FAN WIRES
GROUND
WIRE
LISTED	WHITE SUPPLY
WIRE
CONNECTOR (3)	(NEUTRAL)
GREEN WIRE
(GROUND) FROM	WHITE FAN
HANGER BRACKET	WIRE

GREEN WIRE	BLACK SUPPLY
(GROUND) FROM	(HOT)
HANGER BALL
	NOTE: CEILING COVER
	OMITTED FOR CLARITY.
Figure 12

!WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

3.Screw the two threaded studs (supplied) into the tapped holes in the hanger bracket.

4.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 13).

5.Secure the ceiling cover in place by sliding lockwashers over the threaded studs and installing the two knurled knobs (supplied). (Figure 13). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod. Your fan is now wired to be turned on and off from the fan switch.

CEILING COVER

THREADED STUD LOCKWASHERS (2) KNURLED KNOB

Figure 13

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

Setting Remote Control Operating Frequency

Your Emerson Remote Control Fan receiver and transmitter can be set to operate at one of 16 different frequencies. In most cases you will not need to change the factory set frequency. The frequency should only need to be changed for one of the following reasons:

a. Multiple fans in one location that you wish to operate from one transmitter. (ALL fans should be set at the same frequency.)

NOTE: Your Emerson Remote Control is designed to operate from a distance up to 20 feet from the fan. If you are operating multiple fans with one transmitter you should be no more than 20 feet from any of the fans to ensure that all fans will respond at the same time.

b. Multiple fans in one location that you wish to operate from different transmitters. (ALL fans set to different frequencies.)

c. Interference with other household systems such as your garage door opener.

NOTE: If you change the operating frequency, you must change both the transmitter and receiver to the same frequency. The remote control will not operate unless both the transmit- ter and receiver are set at the same frequency.

Setting Transmitter Frequency

1.Remove battery cover and the battery from the transmitter. Locate the switch with four levers numbered 1, 2, 3, 4, just above the battery compartment (See Figure 14).

2.With a narrow blade screwdriver, change the position of one or more of the four levers on the switch. Note the positions of each of the four levers by number; down is ON, up is OFF.

Setting Receiver Frequency

1.After electricity has been turned off at the main fuse box, remove the switch housing assembly by removing the three mounting screws (See Figure 6).

2.Disconnect the switch housing connector form the motor connector by squeezing the latch and pulling the connectors apart.

3.Remove the receiver from the switch housing and locate the switch with four numbered levers (same as transmitter). (See Figures 14 and 15).

4.Set the position of all four levers, ON or OFF to the same position as those on the transmitter.

5.Install the receiver in the switch housing, push the motor connector into the switch housing connector and assemble the switch housing assembly to the housing plate (See Figures 5 and 6).

7