Lowrance electronic X51 manual Transom

Page 11

Mark the center of each slot for the mounting screw pilot holes. You will drill one hole in the center of each slot.

Drill the holes using the #29 bit (for the #10 screws).

Transom

Transom

Position transducer mount on transom and mark mounting holes.

Side view shown at left and seen from above at right.

5.Attaching transducer to transom. Remove the transducer from the bracket and re-assemble it with the cable passing through the bracket over the bolt as shown in the following figures.

Route cable over bolt and through bracket. Side view shown at left and

seen from above at right.

Attach the transducer to the transom. Slide the transducer up or down until it's aligned properly with the bottom of the hull as shown in the preceding and following figures. Tighten the bracket's mounting screws, sealing them with the sealant/adhesive compound.

Adjust the transducer so that it's parallel to the ground and tighten the nut until it touches the outer washer, then add 1/4 turn. Don't over tighten the lock nut! If you do, the transducer won't "kick-up" if it strikes an object in the water.

9

Image 11
Contents X51 Pro Visit our web site Table of Contents Capabilities and Specifications X51 Pro Transducer Installation Installation PreparationsSelecting a Transducer Location Recommended Tools and suppliesGood and poor transducer locations Shoot-thru-hull vs. Transom Mounting How low should you go?Transom Transducer Assembly and Mounting Insert bolt and check transducer position on transom Transom Trolling Motor Bracket Installation Attach motor mounting bracket to transducer Hulls With Floatation Materials Transducer Orientation and Fish ArchesShoot-Thru Hull Preparation Testing Determines Best Location Shoot-thru-hull Installation Epoxy transducer to hull Power and Cable Connections Bracket Mounting the Sonar UnitBracket Installation Portable Sonar Installation Portable Transducer Assembly Installing the BatteriesKeyboard OperationDisplay MenusFull Chart Chart ScrollZoom Depth Range ZoomSensitivity Grayline Fishtrack Fish I.DFish Alarm Chart Scroll SpeedAlarms Noise Reject and ASP Advanced Signal ProcessingDeep Alarm Depth AlarmsShallow Alarm Display Contrast Battery VoltagePreset Unit BacklightDigital Data Size Depth and Temp SimulatorIndex Unit freezes, locks up, or operates erratically Unit turns on only in simulator modeUnit wont turn on Noise No fish arches when the Fish I.D. feature is offNavico Full ONE-YEAR Warranty Not toll-free How to Obtain Service…Accessory Ordering Information for all countries Visit our web site