Emerson CF742PFWW 01, CF742PFSCB 01 warranty Tools Needed for Assembly, Unpacking Instructions

THIS FAN IS SUITABLE FOR DAMP LOCATIONS SUCH AS

COVERED PORCHES, COVERED PATIOS, AND COVERED DECKS.

ANYWHERE THERE IS A ROOF OVERHEAD.

This Manual is Designed to Make it as Easy as

Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver

One stepladder

One wire stripper

Three wire connectors (supplied).

MATERIALS

Wiring, electrical box and box connectors must be of type required by the local code. The minimum wiring would be a 3-conductor (2-wire with ground) of following sizes:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50 - 100 ft.	12

!WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 5). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each assembly step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

Check to see that you have received the following parts:

a.Fan motor assembly

b.Five fan blades

c.One ceiling cover

d.Five blade flanges

e.One hanger ball/downrod assembly

f.One hanger bracket.

g.One loose parts bag containing:

1.Sixteen M5 x 10 washer head blade screws

2.One M5 x 13 flange screw

3.One pull chain pendant

4.One pull chain coupling

5.Three wire connectors

6.One clevis pin

7.One hairpin clip

8.Two threaded studs

9.Two lockwashers

10.Two knurled knobs

NOTE: Place the parts from the loose parts bag in a small container to keep them from being lost.

How to Put Your Ceiling Fan Together

1. Pass the 80" motor leads through the opening in the ceiling cover. Be sure the cover is oriented correctly.

2. Separate, untwist and unkink the three motor leads. Route the motor leads through the hanger ball/downrod assembly.

3. Remove the two setscrews from the motor coupling. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 1). The clevis pin must go through the holes in the motor

coupling and the holes in the downrod. Be sure to

3

push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the clip snaps around the clevis pin. Pull on the hanger ball to make sure the clevis pin is properly installed.

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.

U.L. Model No.: CF742PF