EditingTroubleshooting, Problem Check point

EditingTroubleshooting

Editing To/From Another Recorder

Player

40	10-
40
32
RF OUT	AUDIO	IN	OUT
K	AUDIO
K
G
ANT.	VIDEO
IN
1-

Audio/Video signals

Problem	Check point
No power	Is the power cord plugged
	in?
	Is the power turned on?
Tape cannot be ejected	Was the video cassette
	player’s ¤button pressed?
No picture	Is the TV set to the video
	channel?
	Is a cassette loaded?
	Are the connections correct?

No colour	Set the Colour System Out-
	put switch according to the
	recorded tape system.
	When playing a MESECAM
	tape, select the NTSC 4.43
	mode.

Shuttle search does not	Is the video cassette player
function	in the playback mode?
Disturbances in playback	Is tracking adjusted properly?
picture	Is the TV adjusted properly?
	Install this VCP a little way

RF OUT

ANT.

Recorder

10-

AUDIO

VIDEO

IN OUT

	apart from the TV set.
Remote control does not	The batteries are weak.
function	Replace the batteries.
Auto playback does not	The video cassette’s record-
function	ing safety tab has not been
	removed.

Receiver

VIDEO CHANNEL

Recording does not func-	Are the connections correct?
tion	Was the Record button
	pressed?
	The video cassette’s record-
	ing safety tab is removed.

The video cassette player	Microcomputer malfunction.
does not function properly	Disconnect the power plug
	from the AC outlet and then

1 Connect the player’s AUDIO and VIDEO OUT connectors to the recorder’s AUDIO and VIDEO IN connectors.

2 Put the player in the Play mode.

3 Put the recorder in the Record mode.

Notes:

∙NTSC tapes being played back in the NTSC PLAYBACK ON PAL TV mode cannot be dubbed to another recorder.

∙When you dub an NTSC tape using your recorder as the playback deck, select NTSC 3.58 (or 4.43) with the Colour System Output switch.

∙Connections made to the front panel AUDIO/VIDEO input terminals automatically override those made to the rear panel AUDIO/VIDEO input terminals.

Important:

7To edit, both the player and the recorder must be of the same colour system. Press your recorder’s Colour sys- tem switch to select the appropriate colour system.

re-insert it.

The microcomputer will be

reset to its initial mode.

About Head cleaning

7If the picture playback becomes blurred, it does not mean that the recorded program has been erased.

7Dirt accumulated on the video heads after long periods of use causes such troubles. In this case, head cleaning requiring highly technical care is necessary.

7For head cleaning, consult the nearest JVC dealer.