Emerson CF725GES00, CF725GBZ00 owner manual Operating Your, Ceiling Fan

BP7369 Vienne 12/7/08 5:21 PM Page 11

9. Position

the

housing

downlight

Operating Your

assembly on the light fitter adapter plate

Ceiling Fan

so that the two screws mate with the

keyhole slots in the housing downlight

IMPORTANT

assembly. Make sure that all wires and

Fan installation must be completed,

wire connectors are positioned within

including the installation of the fan

the housing downlight assembly. Rotate

blades, before testing of the remote

the

housing

downlight

assembly

control.

clockwise and tighten the two screws.

Your

Fan/Light

Wall

Control

(Figure

15)

Install the other M4 x 8mm oval head

has

full

control

of

your

fan

and lights.

screw

in the

remaining hole in the

However, airflow direction is controlled by

housing downlight assembly.

a slide switch on the switch housing.

!

WARNING

1. Restore electrical power to the outlet

box by turning the electricity on at the

Make sure there are no wires pinched

service panel.

between the

light fitter and

the fitter

2. To set the desired fan speed, press the

adapter plate.

HI, MED, or LOW buttons to operate

HOUSING

INSTALL THREE M4 x 8mm

your fan on high, medium, or low speed

OVAL HEAD SCREWS

(Figure 15).

DOWNLIGHT

ASSEMBLY

3. To turn your fan off, press the OFF

button.

4. To set the level of light brightness,

60-WATT (MAX.)

press and hold the LIGHT button. The

HOUSING

light

brightness

will

continue

to

CANDELABRA

DOWNLIGHT

BULB (2)

increase then decrease

while

the

ASSEMBLY

button is held down. When the lights are at the desired brightness, release the button.

GLASS

BOWL

WASHER

HEX NUT

Figure 14

FINIAL NUT

10. Screw in two 60-watt (maximum) candelabra bulbs (supplied) in the light fitter sockets (Figure 14).

11. Remove the finial nut, hex nut and washer from housing downlight assembly.

12. Position the glass over the threaded nipple. Slide the washer onto the threaded nipple and gently tighten the hex nut to secure the glass and washer. Install finial nut finger tight (Figure 14).

13. Your ceiling fan is now installed and wired to be controlled by your SW102 Fan/Light Wall Control.

5. To turn the lights on and off, press and release the LIGHT button. The lights will turn on at the light level previously set (see step 4).

6. If airflow is desired in the opposite direction, turn the fan off and wait for the blades to stop turning. Then slide the reversing switch (on the motor and upper housing assembly) to the opposite position (Figure 16) and turn the fan on again. The blades will turn in the opposite direction and reverse the airflow.

11 U.L. Model No.: CF725