Specifications, Warranty | Spectra HL450 instruction

Specifications

Working Radius:	1 m - 200 m (3 ft - 650 ft)
(Laser dependent):
Laser Detection Height:	102 mm	(4“)
Numeric Readout Height:	76 mm	(3“)
Accuracy (Dead band):
Fine	1.0 mm	0.05 in	1/16 in
Medium	5.0 mm	0.20 in	1/4 in
Calibration	0.1 mm	0.01 in	1/64 in
Reception Angle:	± 45° minimum
Detectable Spectrum:	610 nm ... 900 nm
Beeper Volumes:	Loud = 100+ dBA
	Low = 65 dBA
Power Supply:	2 x 1.5 Volt “AA” batteries
Battery Life:	70+ hours
Automatic Shut Off:	30 min
Environmental:	Waterproof, Dustproof to IP67
Weight without clamp:	371 g (13.1 oz.)
Dimensions without clamp:	168.0 x 76.0 x 36.0 mm
	(6.6” x 3.0” x 1.4”)
Operating Temperature:	-20°C...+60°C (-4°F... +140°F)
Storage Temperature:	-40°C...+70°C (-40°F...+158°F)

*Specifications subject to change without notice.

Warranty

Trimble warrants the HL450 to be free of defects in material and workmanship for a period of three years. (3 year limited, 2 years free exchange, 3rd year a fee is charged.) Trimble or its authorized service center will repair or replace, at its option, any defective part, or the entire product, for which notice has been given during the warranty period. If required, travel and per diem expenses to and from the place where repairs are made will be charged to the customer at the prevailing rates. Customers should send the product to Trimble Navigation Ltd. or the nearest authorized service center for warranty repairs or exchange, freight prepaid. Any evidence of negligent, abnormal use, accident, or any attempt to repair the product by other than factory-authorized personnel using Trimble certified or recommended parts, automatically voids the warranty. The foregoing states the entire liability of Trimble regarding the purchase and use of its equipment. Trimble will not be held responsible for any consequential loss or damage of any kind. This warranty is in lieu of all other warranties, except as set forth above, including any implied warranty merchantability of fitness for a particular purpose, are hereby disclaimed. This warranty is in lieu of all other warranties, expressed or implied.

HL450 Laserometer

User Guide

www.trimble.com

2				4

EMC Declaration of Conformity

This receiver has been tested and found to comply with the limits for a Class B digital device for radio noise for digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Com- munication, and is pursuant to part 15 of the Federal Communication Commission (FCC) rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation. This receiver generates radio frequency. If it’s not used in accordance with the instructions, it may cause harmful interference to radio or televi- sion reception. Such interference can be determined by turning the re- ceiver off and on. You are encouraged to try eliminating the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the laser and the receiver. For more information, consult your dealer or an experience radio/television technician.

CAUTION: Changes or modifications to the receiver that are not ex- pressly approved by Trimble could void authority to use the equipment.

Declaration of Conformity

Application of Council Directive(s):	89/336/EEC
Manufacturer’s Name:	Trimble Navigation Ltd.
Manufacturer’s Address:	5475 Kellenburger Road
	Dayton, Ohio 45424-1099 U.S.A.
European Representative Address:	Trimble GmbH Am Prime Parc 11
	65479 Raunheim, Germany
Model Number:	HL450
Conformance to Directive(s):	EC Directive 89/336/EEC using
	EN55022 and EN50082-1
Equipment Type/Environment:	ITE/residential, commercial
	& light industrial
Product Standards:	Product meets the limit B and
	methods of EN55022
	Product meets the levels and
	methods of IEC 801-2, 8 kV air,
	4 kV contact IEC 801-3, 3 V/m
	26 to 1000 MHz 80%, @ 1 kHz

Notice to Our European Union Customers

For product recycling instructions and more information, please go to: www.trimble.com/environment/summary.html

Recycling in Europe

To recycle Trimble WEEE, call: +31 497 53 2430, and

ask for the “WEEE associate,” or

Mail a request for recycling instructions to:

Trimble Europe BV c/o Menlo Worldwide Logistics Meerheide 45 5521 DZ Eersel, NL

11
10						13
9						13


8
8

Trimble Construction Division

5475 Kellenburger Road

Dayton, Ohio 45424-1099

U.S.A.

+1-937-245-5600 Phone

www.trimble.com

N324

Front view		Rear view
1.	Keypad - Power, Accuracy, Units & Volume switches.	8.	Battery Door & Latch for two “AA” batteries.
2.	Beeper output - Fast, solid & slow audible signal.	9.	Marking Notch (3.15 in / 80.0 mm from top).
3.	Bubble Vial - aids in keeping HL450 level.	10.	Captive Screw Thread
4.	Anti-strobe sensor - Reduces false indication from	11.	Clamp Guides - Dimples align rod clamp.
	strobe lights.	12.	Serial Number / ID Label.
5.	SuperCell Reception Window - 4.0 in / 102 mm of height.	13.	Rear LCD - repeats indications of front LCD.

6.Front LCD - Displays elevation, settings and status.

7.On-grade Mark - Aligned with laser center on-grade reading.

Spectra HL450 warranty Specifications, Warranty, Front view Rear view