Grizzly H2682 manual Level your Adjusting, Accuracy levels the Checking, Machinist’s Level Usage

	Level Large			Nut Jamb
with nut jam top the Loosen					.2
			.spring the lose
not to careful Be .cap end the
out pull to pliers Use .cap side
the in screw the insert level,
12" the have you If .level 8"
the have you if vial, small the
opposite end the on cap, end
the into it insert and plate, side
the from screw a				Unthread	.1
		level: your Adjusting

.adjusted be to needs it					line, a
of half one within reading, first
the opposite up line not does
bubble		the	If .vial large the
in bubble the of note take and
180° exactly level the Rotate						.4
.step next the before surface
the on rests level the where
Mark .vial large the in reading
bubble		the	of	note	Take	.3
		.level the of end one
under shims placing by adjust
also can You .center to close
is bubble the until level the
rotate side, either to pegged
is vial large the in bubble the If						.2
.readings your of accuracy
the	affect		can	dust	and
Dirt .clean wiped is level the of
base the sure Make .surface
clean	a on level the Place .1
accuracy: level's the Checking

Cap End

Screw Plate Side

Vial Large Vial Small

move! will bubble the leveling, are you that machine the under page newspaper a put you If .span 10" a over 0005". of resolution a has H2683 The .span 10" a over 0002". of resolution a has H2682 The .machinery fine other and machines milling lathes, up setting for used are levels accurate incredibly These

the included wrench. Move the bottom nut to adjust the level. Clockwise moves the nut down, and counter-clockwise moves it up. This level is so sensitive that resting your weight on the surface that you are leveling can affect the readings!

3. Recheck the level for

accuracy. Repeat Step 2 if it is not accurate.

4.When accurate, tighten the top jam nut onto the bottom jam nut to lock the adjustment in place. Let the level sit for 2-4 hours and check for accuracy

again.

Machinist’s Level Usage

1.Clean the surface to be leveled and the base of the machinist’s level. Grime and metal shavings will affect the accuracy of the readings.

2.Place your level parallel with the edge and in the center of the surface to be leveled.

3.Adjust the surface to be leveled so that the bubble in the small vial is centered. The bubble should come to a complete stop in the exact center of the vial.

4.Next, adjust the surface so that the bubble in the large vial is centered.

5.Rotate the level 90° and repeat Step 4.

© 2003 Grizzly Industrial, Inc.

H2682 & H2683

MASTER

MACHINIST'S

LEVEL

INSTRUCTIONS

Printed in China