Hilti WSJ 850, WSJ 750 operating instructions Operation

Page 12

Please refer to the information provided with the saw blade for details of correct settings.

6.8Adjusting the stroke rate

1.Set the stroke rate adjustment thumbwheel to a posi- tion between 1 (slow) and 6 (fast).

Please refer to the information provided with the saw blade for details of correct settings.

6.9 Adjusting the cutting angle

6.9.1Setting the cutting angle

1.Unplug the supply cord from the electric socket.

2.Remove the dust removal system adaptor.

3.Release the screw.

4.Pull the baseplate slightly toward the front of the tool.

5.Set the baseplate to the desired angle according to the scale on the tool.

6.Tighten the screw.

6.9.2Resetting the cutting angle

1.Unplug the supply cord from the electric socket.

2.Release the screw.

3.Return the baseplate to the 0° position.

4.Push the baseplate back to its original position (toward the rear of the tool).

5.Tighten the screw.

6.10 Offsetting the baseplate

To facilitate sawing close to edges, the baseplate can be repositioned as follows:

1.Unplug the supply cord from the electric socket.

2.Release the screw.

3.Push the baseplate back as far as it will go.

4.Tighten the screw.

en

6.11Anti-splinter insert -NOTE-

The anti-splinter insert cannot be used with certain types of saw blades (e.g. offset blades).

Use of the anti-splinter insert helps prevent splintering of the surface when sawing wood materials.

1.Unplug the supply cord from the electric socket.

2.Press the anti-splinter insert into the baseplate from below.

6.12Low-friction baseplate cover

-NOTE-

Use the low-friction baseplate cover to avoid scratching sensitive materials.

1.Unplug the supply cord from the electric socket.

2.Hook the cover onto the front edge of the baseplate.

3.Press the cover against the baseplate until it snaps into place.

7. Operation

-CAUTION-

The cutting edges of the saw blade

are sharp.

The cutting edges may present a risk of injury.

Wear protective gloves.

-CAUTION-

The sawing operation swirls up dust and wood chips into the air.

The dust and wood chips may be harm-

ful to the eyes and respiratory system. Wear protective goggles and breath-

ing protection.

-CAUTION-

Operation of the tool creates noise.

Excessive noise may damage the hear- ing.

Wear ear protection.

7.1 System

-NOTE-

To achieve good cutting performance and ease the load on the tool, always use blades that are in good condition.

Do not overload the tool.

-CAUTION-

When working with the tool, always guide it away from the body.

Lift the tool away from the workpiece only after the blade has come to a standstill.

19

Image 12
Contents WSJ 750/850 WSJ 750-ET / WSJ 850-ET WSJ 750-EB / WSJ 850-EB Page III Page General information Tools and accessories DescriptionTechnical data Safety precautions Basic information concerning safetyTake the necessary precautions to make the workplace safe En -ATTENTIONMechanical ElectricalThermal DustBefore use Operation Care and maintenance Troubleshooting Fault Possible cause RemedyWarranty DisposalEC declaration of conformity DesignationType Hilti CorporationHilti Corporation