Epson 28-293 instruction manual Starting Stopping SAW, Locking Switch OFF Position

6.Remove the screw and cable clamp (E) Figs. 15 and 16 from the lower arm of the band saw.

E

7.Insert the switch cord (F) Fig. 16, into the clamp (E) (removed in STEP 6), and fasten the switch cord (F) to the bandsaw.

IMPORTANT: Be certain to prevent contact between the on/off switch-to-motor cord (F) Fig. 16 and the motor pulley or belt. If necessary, adjust the cord, then tighten the cable tie (H) Fig.11.

8. Attach the two side panels removed earlier.

STARTING AND

STOPPING SAW

To start the tool, press the “START” button (K) Fig. 17. To stop the tool, press the “STOP” button (L) Fig. 17.

Fig. 15

F

E

Fig. 16

K

L

Fig. 17

LOCKING SWITCH IN

THE OFF POSITION

IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use, using a padlock (M) Fig. 18 with a 3/16" diameter shackle.

K

M

Fig. 18

8