SAND AD,!NTS
FRONT WHEEL TOE-IN ADJUSTMENT
Front wheel
TO CHECK
o Position front wheels straight ahead°
,Measure distance between wheels at front and rear of tires (dimensions "A" and "B")_
°Front dimension "A" should be 1/8" to 1/4" less than rear dimension "B"°
TO ADJUST
•Loosen jam nuts at adjustment sleeves on tie rod°
°Adjusttie rod until dimension "A" is 1/8" to 1/4" lessthan dimension "B".
,Tighten jam nuts securely.
=B ....... I
FIG. 28
ADJUSTMENT ! SLEEVES
JAM
TIE ROD
FIG. 29
FRONT WHEEL CAMBER
The front wheel camber is not adjustable on your tractor, If damage has occurred to affect the front wheel camber,
contact your nearest authorized service center/depart- ment°
RETAINING
RING
AXLE
COVER
FIG. 30
REAR WHEEL -
"Block rear axle securely°
•Remove five (5) hub bolts to allow wheel removal.
°Repair tire and reassemble. Replace and tighten hub bolts securely.
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 31)
ate explosivegases. Keepsparks, flame
and smoking materials away from bat- CAUTION:
If your battery is too weak to start the engine, it should be
recharged, if "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
°Connect each end of the RED cable to the POSITIVE
(+)terminal of each battery, taking care not to short against chassis.
°Connect one end of the BLACK cable to the NEGA- TIVE
°Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery_
TO REMOVE CABLES, REVERSE ORDER -
-BLACK cable first from chassis and then from the fully charged battery.
°RED cable last from both batteries.
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig. 30) -
°Block up axle securely°
°Remove axle cover, retaining ring and washers to allow wheel removal.
•Repair tire and reassemble°
°Replace washers and snap retaining ring securely in axle groove.
oReplace axle cover..
\
"POSiTiVE" (+) | "NEGATIVE" |
25 | FIG. 31 |
|