Using the engine start feature
Your battery charger can be used to jump start your car if the battery is low. Follow these instructions on how to use the ENGINE START feature.
1.Connect the charger to the battery. (Follow con- necting instructions given in "Charging Your Battery" on page 6.)
2.Set the Selector Switch on ENGINE START.
3.Crank the engine for no more than 7 seconds. If it does not start, wait at least 4 minutes before cranking again. In extreme cold or if the battery is severely discharged, charge the battery for about 5 minutes in the 10 amp postion, before cranking the engine.
4.After the engine starts, unplug the charger power cord from the AC outlet. Then disconnect the charger from the battery.
IMPORTANT: Do not try to start the engine without a battery in it. You could cause damage to the electrical system.
If the engine does turn over, but never starts up, there is not a problem with the starting system, there is a problem somewhere else in the engine. STOP crank- ing the engine until the other problem has been identified and corrected.
Maintenance and care
A minimal amount of care can keep your battery charger working properly for years.
1.Clean the clamps each time you are finished charging. Wipe off any battery fluid that may have come in contact with the clamps to prevent corrosion.
2.Coil the input and output cords neatly when storing the charger. This will help prevent accidental damage to the cords and charger.
3.Occasional cleaning of the case of the charger with a soft cloth will keep the finish shiny and help prevent corrosion.
9
Sears 003 - Sch 549 11/2/95