| SPECIFICATION | CHART |
Model No. | 919.184160 | |
Horsepower | 6.5 HP | |
Displacement CFM at Max. Pressure | 15 | |
Bore |
| 2 718 |
Stroke |
| 2" |
Voltage - Single Phase | 220 | |
Minimum | Branch Circuit Requirement | 20 amp |
*Fuse Type | Fusetron Type "T" | |
Amperage | at Max. Pressure | 15 |
Air Tank Capacity - Gallons | 60 gal ASME | |
Approximate | 100 | |
Approximate | 125 | |
SCFM@ | 90 psig | 10.5 |
SCFM@ | 40 psig | 13.0 |
UL Listed |
| Yes |
*A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same rating as the branch circuit the air compressor is operated on.
GLOSSARY
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of mea- sure of air delivery.
PSIG: Pounds per square inch gauge; a unit of measure of pressure.
ASME:American,Society of Mechanical Engineers; made, tested, inspected and registered to meetthe standards of the ASME.
UL Listed: Underwriters Laboratories; samples of com- pressor outfits taken from production were submitted to UL and found to comply with their requirements for design and performance.
pressure."
To
ACCESSORIES FOR USE WITH SEARS AIR COMPRESSORS
The following accessories are available through the current Power and Hand Tool Catalog or
• | SPRAY GUNS | • | PAINT TANKS | • | AIR TOOLS |
|
|
| Sanders | ||
• | BLOW GUNS | • | AIR TANKS |
| |
• | AIR CAULKING GUNS | • | INFLATOR KITS |
| Drills |
• | AIR POWERED WASHER GUNS | • | QUICK CONNECTOR SETS |
| Impact Wrenches |
• | SAND BLASTERS |
| (various sizes) |
| Hammers |
• | AIR BRUSHES | • | AIR PRESSURE REGULATORS | • | AIR HOSE: |
• | IN LINE FILTERS | " • | OIL FOG LUBRICATORS |
| 1/4", 3/8" OR 1/2" I.D. |
• | TIRE AIR CHUCKS |
|
|
| in various lengths |
5