surface with
8.To repair flexible plastic tabs or any plastic that requires elasticity, sand area with
9.Cut an
Welder is heated, fit mesh piece into corner of tab. Applying the mesh will reinforce the plastic tab.
10.Lightly scuff melted mesh with sand- paper.
11.Melt
12.To repair damaged plastic bolt hole or slot, use sandpaper to taper and smooth broken edges. Apply alumi- num tape (not included) to surround- ing surface if desired.
13.Melt Mesh into plastic gap, refill- ing edge around hole or slot. Apply melted plastic to Mesh and allow to cool.
14.Remove aluminum tape from hole and, if necessary,
15.When welding is finished, unplug the
Power Cord and set the Welder onto the Welder Stand (4) and allow to cool down.
16.Once cool, clean off welding tip using the Wire Brush (5) and then store Kit indoors out of children’s reach.
Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation: Unplug the tool from its electrical outlet and allow to cool before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and
Lubrication
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose screws, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation.
2.After Use, clean external surfaces of the tool with clean cloth.
3.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
4.Always store Welding Kit in a clean, dry and safe location away from children.
SKU 67102 | For technical questions, please call | Page 8 |