Power Acoustik owner manual Connecting the Speakers, Astereo Mode, Bmono Mode, Ctri Mode

OV2-800/OV2-1250/OV2-1800/OV2-2200/OV2-2600

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

CONNECTING THE SPEAKERS

OV2-420/OV2-600/OV2-800/OV2-1250/OV2-1800/OV2-2200/OV2-2600

(A)STEREO MODE

LEFT CHANNEL

2-4Ohm

(B)MONO MODE

9

(C)TRI MODE

TRI MODE OPEATIONAL OUTPUT allows a Crossover(Subwoofer) to be operated in MONO mode while the main speaker is playing in stereo.

Leave the Crossover(Subwoofer)Switch on"FULL" position.

Use a 100Volt,non-polar capacitor for a high pass crossover and a wire coil (inductor)to block high frequencies from the Crossover (Subwoofer)as shown in the figure below. Capacitor and inductor values as written in the below determine the crossover frequencies.

The front and rear channels of this amplifier get this capability. Only the rear left and right channels are shown below.

INDUCTOR

LOW PASS FILTER

CAPACITOR

HIGH PASS FILTER

COMPONENT VALUES FOR 6dB PASSIVE CROSSOVER

FREQUENCY	INDUCTOR	CAPACITOR
80Hz	7.5mH	470uF
100Hz	6.5mH	330uF
120Hz	5.5mH	330uF
150Hz	4mH	220uF

10