Emerson CF925OB00, CF925BK00, CF925WW00, CF925BS00 Unpacking Instructions, Up to 50 ft 50-100 ft

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One 1/4” blade screwdriver	One wire stripper
Three wire connectors (supplied)
One 3/16” hex wrench (supplied)

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 6). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Company. Substitution of parts or accessories not designated for use with this product by Emerson Company could result in personal injury or property damage.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.One ceiling cover

c.Five fan blades

d.Five blade flanges

e.One hanger ball/downrod assembly

f.One hanger bracket

g.One glass globe

h.One SR100 fan/light control

i.One light kit plate

j.One adapter plate

k.One coupler cover

l.One loose parts bag containing:

1.Sixteen 3/16-24 x 5/16” slotted Phillips washer head blade screws

2.Sixteen Fiber blade washers

3.Eleven 1/4-20 x 3/8” Phillips oval head flange screws

4.Three wire connectors

5.Two 3/4" threaded studs

6.Two lockwashers

7.Two knurled knobs

8.One clevis pin

9.One hairpin clip

10.One 3/16” hex wrench

11. Three 3/16-24 nuts 3

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

2.Remove the fan assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the top of the motor facing up.

The upper foam pad serves as a holder for the fan during the first stages of assembly.

COUPLER		HANGER
COVER
		BRACKET
FAN
ASSEMBLY		HANGER BALL/
		DOWNROD
		ASSEMBLY
LIGHT KIT		CEILING
PLATE		COVER
		LOOSE
		PARTS
ADAPTER PLATE		BAG
MED	LOW	SR100
HI	OFF
		FAN/LIGHT
		CONTROL
GLASS
BOWL		BLADE
		FLANGES

FAN BLADES