ASSEMBLY
Fitting the cutting head
(Saw attachment with shaft PA 1100)
•Fit the cutting head on the shaft so that the screw (A) is aligned with the hole in the shaft as shown.
B
A
•Tighten screw A.
•Tighten screw B.
CAUTION! Make sure that the drive shaft inside the shaft engages with the
Fitting the cutting head
(Saw attachment without shaft PA)
•Remove the mitre gear from the shaft.
•Fit the cutting attachment to the shaft.
B |
A
•Tighten screw A.
•Tighten screw B.
CAUTION! Make sure that the drive shaft inside the shaft engages with the
Fitting the bar and chain
•Unscrew the bar nut and remove the protective cover.
•Fit the bar over the bar bolt. Place the bar in its rearmost position. Place the chain over the drive sprocket and in the groove on the bar. Begin on the top side of the bar.
•Make sure that the edges of the cutting links are facing forward on the top edge of the bar.
•Fit the cover and locate the chain adjuster pin (A) in the hole in the bar. Check that the drive links of the chain fit correctly on the drive sprocket (B) and that the chain is in the groove in the bar (C). Tighten the bar nut
•Tension the chain by turning the chain tensioning screw clockwise using the combination spanner. The chain should be tensioned until it does not sag from the underside of the bar.
•The chain is correctly tensioned when it does not sag from the underside of the bar, but can still be turned easily by hand. Hold up the bar tip and tighten the bar nuts with the combination spanner.
•When fitting a new chain, the chain tension has to be checked frequently until the chain is
Fitting the hanging ring
Fit the hanging ring between the rear handle and the loop handle. Position the hanging ring so that the machine is balanced and comfortable to work with.
English – 13