ESPAÑOL
ESPAÑOL
ESPAÑOL
ESPAÑOL
ESPAÑOL
RQTX1097
26
■ USB |
| Page |
The USB drive or its | • The USB drive format or its contents is/are not compatible with the | 20 |
contents cannot be | system. |
|
read. | • The USB host function of this product may not work with some USB | — |
| devices. | — |
| • USB devices with storage capacity of more than 32 gigabytes may not | |
| work in some instances. |
|
|
|
|
Slow operation of the | • Large fi le size or high memory USB fl ash drive takes longer time to | — |
USB device. | read. |
|
|
|
|
■ Unit displays |
|
|
|
|
|
“NO PLAY” | • Check the content. | — |
| • Only MP3 format fi les can be played. | — |
|
|
|
“F61” | • Check and correct the speaker cords connection. | 7 |
| If this does not fi x the problem, consult the dealer. |
|
| • Disconnect the USB device. Turn the unit off and then turn back on. | — |
|
|
|
“ERROR” | • Incorrect operation performed. Read the instructions and try again. | — |
|
|
|
“ERROR” (during | • You are not able to select other playback source (example: radio, USB | 16 |
recording) | and etc.) or press [2/3] or [5/6] during recording. |
|
| Stop the recording function. | — |
| • You are not able to open the disc tray when recording from AM source. | |
| • Select a suitable recording mode (128 KBPS or 192 KBPS) and resume | 19 |
| recording. |
|
|
|
|
“PLAYERROR” | • An unsupported MP3 format is being played. The unit will skip that track | — |
| and play the next one. |
|
|
|
|
• The unit cannot display the remaining play time for variable bit rate | — | |
| (VBR) tracks. |
|
|
|
|
| • You cannot use | 19 |
| Change to digital mode or use normal recording. |
|
|
|
|
“DEVICE FULL” | • You cannot perform recording because the total USB remaining REC | 15 |
| (recording) time of the USB device is less than the total time of the |
|
| music source. |
|
| Change to a USB device which has the appropriate recording time and |
|
| perform the recording again. |
|
|
|
|
System memory reset (Initialisation)
When the following situations occur, refer to the instructions below to reset the memory:
•There is no response when buttons are pressed.
•You want to clear and reset the memory contents.
To reset system memory
1Disconnect the AC mains lead. (Wait at least 3 minutes before proceeding to step 2.)
2While pressing and holding down [1] on the main unit, reconnect the AC mains lead. “– – – – – – –
3Release [1].
All the settings are returned to the factory preset. You will need to reset the memory items.
Maintenance
If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
•Never use alcohol, paint thinner or benzine to clean this unit.
•Before using chemically treated cloth, read the instructions that came with the cloth carefully.
RQT804