Woodstock W1758 owner manual Installing/Removing Faceplate

Page 22

Installing Faceplate

W1758 Owner's Manual (Mfg. Since 3/10)

OPERATIONS

Installing/Removing

Faceplate

The faceplate is used for removing material from the face of the workpiece, such as in hollowing operations. The faceplate can be installed only if the center has been removed from the headstock spindle.

To install the faceplate onto the spindle, do these steps:

1.DISCONNECT THE LATHE FROM POWER!

2.If the headstock center is installed, remove it (refer to Page 18 for instructions).

3.Thread the faceplate onto the headstock spindle.

4.Using the two included 34mm flat wrenches, tighten the faceplate, as shown in Figure 21.

Note: To remove the faceplate, reverse Steps 3–4.

For detailed instructions on mounting a workpiece to the faceplate, refer to Faceplate Turning on Page 24.

Figure 21. Tightening faceplate onto

headstock spindle.

Always make sure that the workpiece is firmly attached to the faceplate and the faceplate is fully tightened onto the headstock spindle before turning the lathe ON. Otherwise the spinning workpiece or faceplate could fly off the spindle and cause death or seri- ous personal injury.

-20-

Image 22

Contents OWNERS MANUAL Model W1758Page Contents Introduction Woodstock Technical SupportMachine Specifications Shipping Dimensions Carton Controls and Features Safety Standard Safety InstructionsAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes 110V Operation Electrical SpecificationsElectrical Extension CordsInventory SetupUnpacking Box 1 Inventory Figures QtyMachine Placement Cleaning MachineMounting to Shop Floor AssemblyTo assemble your lathe, do these steps Securing lathe to legs Test Run To test run the machine, do these stepsOperations GeneralTo swivel the headstock, do these steps Adjusting HeadstockLoosen the headstock locking handle see Figure Adjusting Tailstock Adjusting Tool RestTo install the headstock spur center, do these steps Installing/Removing Headstock CenterTo remove the headstock spur center, do these steps To install the tailstock live center, do these steps Installing/Removing Tailstock CenterTo remove the tailstock live center, do these steps Installing/Removing Faceplate To install the faceplate onto the spindle, do these stepsSelecting Turning Tools Example of a gougeTo set up a spindle turning operation, do these steps Spindle TurningWhen it is in contact with Refer to Installing Tailstock Center on Page 19 forIng on the tool rest when preparing Do not press the workpiece tooFaceplate Turning To mount your workpiece to a backing block, do these stepsSanding/Finishing Using Lathe Outboard TurningAccessories Wood Lathe AccessoriesLathe Bed MaintenanceCleaning LubricationChanging V-Belt Aligning Headstock Tailstock CentersTo change the V-belt, do these steps Electrical Components & Wiring Diagram VAC BkTroubleshooting Motor & ElectricalLathe Operation Parts Parts List DescriptionLabel Placement 196 199 197 193195 198Warranty Registration CommentsWoodstock international inc. p.o. box Bellingham, wa Warranty High Quality Machines and Tools