13.STAYALERT. Watch what you are doing. Do not operate Lathe or assemble or setup this Stand when you are tired.
14.DO NOT ASSEMBLE WHILE UNDER THE INFLUENCE OFALCOHOL, DRUGS, OR PRESCRIPTION MEDICINES.
15.CHECK FOR DAMAGED PARTS. Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts, any broken parts or mounting fixtures, and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. Do not use the tool if any switch does not turn on and off properly.
16.REPLACEMENT PARTSANDACCESSORIES. When servicing, use only identical replacement parts intended for use with this tool. Replacement parts are available from Harbor Freight Tools. Use of any other parts will void the warranty.
ASSEMBLY INSTRUCTIONS
PLEASE REFER TO THE ASSEMBLY DIAGRAM AND PARTS LIST ON PAGES 6 AND 7 OF
THIS MANUALAND TO THE MANUAL FOR THE 43681 LATHE
1.Position the Headstock Stand (1) and Tailstock Stand (11) on the shop floor. Place the Headstock Stand (1) on the left, and Tailstock (11) on the right in the position you intend to operate the machine. Be sure the doors face front.
2.Using the included hardware, fasten the Headstock Connecting Strip (2) to the Headstock Stand
(1) and the Tailstock Connecting Strip (12) to the Tailstock Stand (11). Then fasten the Connect ing Plate (4) to the two stands.
3.Compare the
Figure 1. Overall dimensions of Lathe’s oil tray. The mounting holes on the oil tray should aling with the mounting holes on Headstock and Tailstock Stands.
4.Check to be sure that the stands are level and stable on the shop floor. If you need to repair the floor, do it now to be sure you have a solid, level surface to mount the machine.
Page 4 SKU # 95647