INTRODUCTION
Commentary | Cover Removal | |
|
|
|
|
|
|
The Model G8143 Collet Closer allows you to quickly interchange
Most importantly, we stand behind our tools. If you have any service questions or parts requests, please call or write us at the location listed below.
Grizzly Industrial, Inc.
1203 Lycoming Mall Circle
Muncy, PA 17756
Phone: (570)
Fax: (800)
http://www.grizzly.com
Disconnect power to your lathe before beginning installation of the Model G8143 Collet Closer.
To begin assembly, follow these initial safety instructions.
1.Disconnect the lathe from the power source!
2.Remove the chuck or any other device that is mounted to the spindle. (Refer to your ownerÕs manual.)
3.Make sure the
Mounting the Model G8143 requires the use of a few simple tools.
Tools Required:
—Adjustable wrench
—3MM hex key
—4MM hex key
To remove the lathe cover and the mounting studs:
Remove the end cover from the lathe by unscrewing the cover knobs on the left end of the lathe as shown in Figure 1.
Figure 1. Lathe cover removal.
|
|
|
|
|
|
|
|
|
|
|
|
G8143 Collet Closer |