Assembly |
| Test Run |
|
|
|
|
|
|
To install the tool rest:
1.Turn the release lever on the tool rest base so it does not interfere with assembly.
2.Thread the tool rest lock handles into the tool rest base (Figure 6) until the threaded ends of the handles are flush with the inside of the shaft.
|
|
|
|
|
|
|
|
|
|
|
|
|
| Tool Rest |
|
| |
|
|
|
|
| Base |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Lock |
|
|
|
|
|
|
|
| Lock Handle |
|
|
| ||||
| Handle |
|
|
| ||||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Release Lever |
| |||
|
|
|
|
|
|
|
|
|
Figure 6. Tool rest lock handles installed onto
tool rest base.
3.Insert the tool rest into the shaft and turn the handles to lock it as shown in Figure 7.
Figure 7. Tool rest installed.
4.Install the optional bed extension, Model G0625 (Page 21). Refer to the instruction sheet included with the bed extension.
Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.
The test run consists of verifying the following: 1) The motor powers up and runs correctly, and 2) the safety paddle switch works correctly.
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 24. If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.
To test run the machine:
1.Make sure that you have read the safety instructions at the beginning of this manual and that the machine is setup properly.
2.Connect the machine to the power source.
3.Flip the paddle switch up to turn the machine ON. Make sure that your hand stays poised over the switch in case you need to quickly turn the machine OFF.
4.Turn the machine OFF.
5.Remove the safety key and attempt to turn the machine ON.