9.Place
10.Tension
11.Place pulley cover over both pulleys and fasten to stand using three pan head screws, six washers, and three hex nuts, as shown in item D, page 7. See Figure 9.
12.Attach trunnion support bracket to saw body with two hex cap screws and two lock washers as shown in item E, page 7. See Figure 10.
13.Thread nut onto table stop bolt (Figure 10) and attach to trunnion support bracket.
14.To mount table, remove table insert and table pin (see Figure 11). Orient the table so that the saw blade will pass through the slot in the table and into the center opening. Continue holding up the table, and turn the table so the two screws that are hanging vertically from below the table will slide into the holes on the trunnion support bracket. Lower the table. The screws should now protrude below the trunnion support bracket - attach lock knobs to the ends of these screws. See Figure 11.
15.
16.Join motor plug to switch plug.
17.Transportation and handling may have caused some fasteners to loosen. Before operating, check all screws, bolts, and nuts to make sure they are snug. Operate machine only after reading the entire manual including blade tracking, blade guide adjustments, and safety rules.
18.Exposed metal surfaces, such as the table, have been given a protective coating. This should be cleaned with a soft cloth and solvent, such as kerosene. Do not use acetone, gasoline, or lacquer thinner. Do not use an abrasive pad, and do not get solvents on plastic parts.
Proceed to “Grounding Instructions” on page 14.
Figure 8
Figure 9
Figure 10
Figure 11
11