Shut-Off Switch
Remove the screw and hex nuts which held the bow to the base during shipment. These should be retained in case of future transportation of the Band Saw.
The screw below the limit switch, shown in Figure 4, has been
Coolant Hose
Before operating, the coolant drain hose (Figure
5)must be connected to the coolant pan and the other end of the hose placed into the filter cup in the tank as shown.
The hose from the coolant pump is attached to a valve which should be inserted into the hole on the guide assembly (see Figure 17).
Grounding Instructions
Electrical connections must be made by a qualified electrician in compliance with all relevant codes. This machine must be properly grounded to help prevent electrical shock and possible fatal injury.
This machine must be grounded. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock.
This band saw is
Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified electrician.
Improper connection of the equipment- grounding conductor can result in a risk of electric shock. The conductor, with insulation having an outer surface that is green with or without yellow stripes, is the equipment- grounding conductor. If repair or replacement of the electric cord or plug is necessary, do not connect the
Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or if in doubt as to whether the machine is properly grounded.
Figure 4
Figure 5
Figure 6
9