Unpacking
Remove all crating and plastic from around the Mortiser. Check for shipping damage; report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Mortiser is assembled and running properly.
Open the cabinet rear door and remove any boxes and accessory items. Compare these with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.
Contents of the Shipping Container
1Mortiser
1Handle
1Chisel and Auger set – 3/4”
1Chisel and Auger set - 1”
3Bushings - 5/8”, 3/4” and
(NOTE: The 5/8” bushing is already installed on the mortiser)
3Combination Wrenches:
4Hex (Allen) Wrenches: 3, 4, 5 and 6mm
1 Chuck Key
1Chuck Extension Adaptor
1Wood Table
2Phillips Flat Head Screws, M6 x 20L
1Reversible (Cross Point/Flat Head) Screwdriver
1Owner's Manual
1Warranty Card
Read and understand the entire contents of this manual before attempting
7