Jet Tools JML-1014I, JWL-1220 operating instructions Unpacking, Assembly

Unpacking

1.Remove contents from the shipping box.

2.Inspect contents for shipping damage and report damage, if any, to your distributor.

3.Be sure to keep the box and packing material should you need to pack the lathe for moving.

4.Do not clean the lathe with anything other than a damp cloth or a mild solvent. Use of heavy solvents, paint thinner, gasoline, etc. will damage painted surfaces.

Contents of the Shipping Carton:

JML -1014I		JWL-1220
1	– Lathe	1 – Lathe
1	– 6” Tool rest	2 – Tool rests (6”,10”)
1	– Face plate	1 – Face plate
1	– Drift rod	1 – Drift rod
1	– Live center	1 – Live center
1	– Spur center	1 – Spur center
1	– Safety goggles	1 – Safety goggles
1	– Owner’s manual	1 – Tool caddy
1	– Warranty card	1 – Work lamp (bulb
1	– 3mm hex wrench	not included)
1	– 5mm hex wrench	1 – Owner’s manual
		1 – Warranty card
		1 – 3mm hex wrench
		1 – 5mm hex wrench

Assembly

The JML-1014Iis fully assembled and comes ready to use right out of the box. However, it is a good practice to thoroughly check the machine for loose fasteners, handles, etc. before use.

The JWL-1220requires minor assembly: Install the tool caddy using the two pan head screws, as shown in Figure 1. The JWL-1220 is provided with a lifting handle on each end. These can be pushed in when not in use.

If desired, the lathe can be bolted to a work table or stand by removing the rubber feet and inserting screws through the holes in the base. IMPORTANT: The table or stand should have an opening directly beneath the motor to prevent build-up of shavings around the motor’s fan housing.

A stand specifically made for the lathe is available from WMH Tool Group. See stock numbers on page 6 for ordering.

8

Figure 1 – Model JWL-1220 only