ADJUSTING MITER GAGE
The miter gage (A) Fig. 30, can be installed at three po- sitions on the table, left, right or center, depending on the drilling operation.
1.To adjust the position and angle of the miter gage (A) Fig. 30, loosen lock knob (B).
2.Tighten lock knob after adjustment is made.
B
A
Fig. 30
ADJUSTING
TABLE HEIGHT
The table (A) Fig. 31, moves on dovetailed ways (B) at the front of the machine.
1. To raise or lower table (A) Fig. 31, rotate knob (C).
A
CB
Fig. 31
ADJUSTING SPEED/FEED RATE OF CARRIAGE ASSEMBLY
The forward speed/feed rate of carriage assembly (A) Fig. 32, is governed by the air pressure. To adjust the speed/feed rate of carriage assembly (A) Fig. 32, proceed as follows:
1.Make certain the machine is disconnected from the power source.
2.Loosen locknut (B) Fig. 32, and rotate air pressure valve (C) as necessary. NOTE: Rotating pressure valve
(C) clockwise will decrease air pressure and slow up carriage (A) movement. Rotating air pressure valve (C) Fig. 32, counterclockwise will increase air pressure and speed up carriage (A) movement.
3.Tighten locknut (B) Fig. 32, after speed/feed rate of carriage assembly (A) is made.
B
A
C
Fig. 32
13