DeWalt DWS7085 instruction manual Use of Miter Saw Worklight System, Maintenance, Specifications

Page 5

3. Tuck the wire connection into the area in the worklight as shown. Attach the worklight to the saw.

4. Attach the worklight with the four screws removed in Step 1. Tighten screws securely.

WARNING: Do not operate the miter saw if any of the screws are missing, stripped out or not seated.

5.Manually open and close the guard to ensure no binding occurs. With the guard closed, move the saw arm through a

full stroke to also ensure no guard binding occurs.

WARNING: To reduce the risk of serious personal injury, Do not operate the saw if guard binding occurs.

Use of Miter Saw Worklight System

WARNING: Read all instructions for the Installation of Worklight Power Supply and the Installation of Worklight before using the

Miter Saw Worklight System.

C

NOTE: The miter saw must be connected to a power source.

The Miter Saw Worklight System is equipped with an ON/OFF switch (C). The Miter Saw Worklight System is independent of the miter saw’s trigger switch.

MAINTENANCE

WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories.

WARNING: To reduce the risk of serious personal injury, DO NOT touch the sharp points on the blade with fingers or hands while performing any maintenance.

For the best worklight performance, perform the following maintenance regularly.

Carefully clean sawdust and debris from worklight lens with a cotton swab.

DO NOT use solvents of any kind, they may damage the lens.

Dust build-up can block the worklight and prevent it from accurately indicating the line of cut.

Follow miters saw’s instruction manual to remove and install blade.

With blade removed from saw, clean pitch and build-up from blade. Pitch and debris can interfere with the worklight and prevent it from accurately indicating the line of cut.

 

SPECIFICATIONS

Light Source

Power LED

Worklight

3.3 V DC

Power Supply

Input: 120–240 V AC; 50/60 Hz

 

Output: 3.3 V DC, 0.9 A

Operating Temperature 32°F to 104°F (0°C to 40°C)

Storage Temperature

0°F to 185°F (-40°C to 85°C)

Environmental

Water Resistant

English

3

Image 5
Contents DWS7085 Heavy-Duty Miter Saw LED Worklight System Page Installation of the Worklight Power Supply WPS Safety Instructions for WorklightsInstallation of Miter Saw LED Worklight System Installation of the Worklight Use of Miter Saw Worklight System MaintenanceSpecifications Year Free Service Three Year Limited WarrantyDAY Money Back Guarantee RepairsTroubleshooting Guide Conserver CES Directives Installation DU Bloc D’ALIMENTATION DE LA Lampe DE TravailInstallation DE LA Lampe DE Travail Lame ne se produit Garantie limitée trois ans EntretienRéparations Guide de dépannage Conserve Estas Instrucciones Instrucciones de seguridad para las luces de trabajoInstalación DE LA LUZ DE Trabajo Instalación DE LA Fuente DE Energía DE LA LUZ DE Trabajo WPSUso del sistema de luz de trabajo para sierra ingletadora Garantía limitada de tres años MantenimientoReparaciones Guía de detección de problemas Page