UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene. (Do not use acetone, gasoline or lacquer thinner for this purpose.) After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
1.Remove the four bolts (A) Fig. 1 (three of which are shown) that attach the saw (B) to the shipping skid.
2.Save the four bolts to permanently mount the saw to a supporting surface.
B 
A
A
Fig. 1
THIS MACHINE IS HEAVY AND CAN TILT EASILY. USE FOUR OR MORE PEOPLE TO SLIDE THE MACHINE OFF OF THE SHIPPING SKID.
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
*5mm Hex Wrench (supplied)
*Phillips head screwdriver (not supplied)
ASSEMBLY TIME ESTIMATE - 2 to 4 hours
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED, AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
ON/OFF SWITCH
1.Remove the two screws (A) Fig. 3 on the cover of the on/off switch, and remove the front cover.
2.Align the two holes of the On/Off switch with the two holes (B) Fig. 4 on the front of the saw.
3.Thread the two screws (located loose in the switch box) into the two holes in the front of the saw and tighten securely.
4.Replace the front cover of the On/Off switch that was removed in STEP 1.
A
B
| A |
Fig. 3 | Fig. 4 |
9