ASSEMBLY INSTRUCTIONS
NOTE: For additional information regarding the parts mentioned in the following pages, refer to the Assembly Diagram on page 22.
To Attach The Rip Guide, And Adjust The Width Of A Cut:
1.WARNING! Prior to performing this procedure, make sure the Trigger Switch (66) of the Saw is in its’ “OFF” position and the Power Cord (71) is unplugged from its electrical outlet.
2.Slightly loosen the two Pins (29). (See Figure D.)
3.Slide the arms of the Rip Guide (73) through the slots in the Base (24).
(See Figure D.)
4.Featured on the arm of the Rip Guide (73) is a width scale, divided in increments of 1/16”. To adjust the width of the cut, slide the arm of the Rip Guide to the right or left until the desired width is acquired. Then, retighten the Pins (29) to hold the Rip Guide in place. (See Figure D.)
RIP GUIDE (#73)
BODY (#32)
BASE (#24)
TOP
VIEW
PIN (#29) |
|
|
| PIN (#29) |
| ||||
|
|
|
SIDE HANDLE
(#72)
FIGURE D
To Attach The Side Handle:
To attach the Side Handle (72), simply screw the Side Handle into the threaded mounting hole located in the upper/left Body (32) of the Saw. (See Figure D.)
SKU 94362 | For technical questions, please call | Page 13 |